INTELLINET NETWORK 525251 300N High-Power PoE Access Point User Manual - Manual (Page 68)

62
2-10-2 IP Address of the Wireless Access Point
You can change the IP address of this wireless access point so it
can become a part of your local network. Remember this address
or you won’t be able to connect the configuration menu of this
wireless access point.
The default IP address is 192.168.2.1; the subnet mask is
255.255.255.0. Press and hold “Reset/WPS” longer than 10
seconds to change the IP address back to the default value if you
forget the IP address you set.
To change the IP address, click System Utility on the left, and the
following message will be displayed:
Input the IP address and subnet mask in the corresponding fields,
and input the IP address of the gateway in the “Gateway Address”
field if you need to manage this wireless access point from another
network (like the Internet).
To activate the DHCP server function of this wireless access point,
select “Enabled” in the “DHCP Server” option, and refer to the next
section for detailed instructions; if you don’t want to use the DHCP
server function of this wireless access point, or if there’s another
DHCP server on the network that this access point connects to,
select “Disable.”