INTELLINET NETWORK 525251 300N High-Power PoE Access Point User Manual - Manual (Page 40)

34
2-4-5 AP Bridge-WDS Mode
In this mode, this wireless access point will connect to up to four
wireless access points that use the same mode, and all wired
Ethernet clients of every wireless access point will be connected
together. You can use this mode to connect a network to other
networks that are physically isolated.
When you use this mode, this access point is still able to accept
wireless clients.
When you select AP Bridge-WDS, the following options will be
displayed:
Here are descriptions of every setup item:
Band
Select the wireless band you wish to use. By
selecting different band settings, you’ll be able
to allow or deny the wireless client of a certain
band.
If you select 2.4 GHz (B), 2.4 GHz (N) or 2.4
GHz (G), only wireless clients using the
wireless band you select (802.11b, 802.11 N or