INTELLINET NETWORK 525251 300N High-Power PoE Access Point User Manual User Manual

Page 33

Here are descriptions of every setup item:

Band

Select the wireless band you wish to use. By

selecting different band settings, you’ll be able

to allow or deny the wireless client of a certain

band.

If you select 2.4 GHz (B), 2.4 GHz (N) or 2.4

GHz (G), only wireless clients using the

wireless band you select (802.11b, 802.11 N or

802.11g) will be able to connect to this access

point.

If you select 2.4 GHz (B+G), then only wireless

clients using 802.11b and 802.11g bands will

be able to connect to this access point.

If you want to allow 802.11b, 802.11g and

802.11 N clients to connect to this access

point, select 2.4 GHz (B+G+N).

Main ESSID

Input the ESSID (the name used to identify this

wireless access point) here. You can input up

to 32 alphanumerical characters. NOTE:
THE ESSID IS CASE SENSITIVE.

Site Survey

When you use this access point as a wireless

station for an Ethernet network device to have

wireless capability, you have to associate it

with a working access point. Click “Select Site

Survey” and “Wireless Site Survey Table” will

pop up. It will list all available access points

nearby. You can select one access point in the

table and it will join the wireless LAN through

this access point. Go to Section 2-4-2-1 for

more information about the Wireless Site

Survey Table.

After you finish with the settings, click “Apply” and the following
message will be displayed:

This manual is related to the following products: