INTELLINET NETWORK 525251 300N High-Power PoE Access Point User Manual User Manual

Page 38

2-4-4 AP Bridge-Point to Multi-Point Mode

In this mode, this wireless access point will connect to up to four
wireless access points that use the same mode, and all wired
Ethernet clients of every wireless access point will be connected
together. You can use this mode to connect a network to other
networks that are physically isolated.

NOTE:

When you set your access point to this mode, it will not

accept regular wireless clients anymore.

When you select AP Bridge-Point to Multi-Point, the following
options will be displayed:

Here are descriptions of every setup item:

Band

Select the wireless band you wish to use. By

selecting different band settings, you’ll be able

to allow or deny the wireless client of a certain

band.

If you select 2.4 GHz (B), 2.4 GHz (N) or 2.4

GHz (G), only wireless clients using the

wireless band you select (802.11b, 802.11 N or

802.11g) will be able to connect to this access

point.

This manual is related to the following products:

524735 Wireless 300N PoE Access Point User Manual 524728 Wireless 300N PoE Access Point User Manual 524704 Wireless 300N PoE Access Point User Manual