INSTEON SwitchLinc Dimmer 100-277VAC (dual band) (2478D) Manual - Manual (Page 9)

Page 9 of 19 2478D - Rev: 1/21/2014 7:32 AM
On LED
Off LED
Using SwitchLinc
LEDs
LED Status Meaning
Bottom LED of
Brightness Bar
On
SwitchLinc
powered up
load off
LEDs on
Brightness Bar
On
Level of load
brightness
load on
• On LED (White)
o Illuminated when SwitchLinc is On
• Off LED (White)
o Illuminated when SwitchLinc is Off
Using the Paddle
Paddle Tap Double-tap Press & hold begin Press & hold end
Top
Turn On
Connected load ramps to set
brightness & Scene
Responders
Connected load
quickly comes
On to full bright
& Scene
Responders
Connected load
gradually brightens &
start brightening Scene
Responders
Connected load &
Scene Responders
stop brightening
Bottom
Turn Off
Connected load ramps to
full Off & Scene Responders
Connected load
quickly turns Off
& Scene
Responders
Connected load
gradually dims & Start
dimming Scene
Responders
Connected load &
Scene Responders
stops dimming
• Tap paddle top to make load turn on at local ramp rate, from present brightness to local On-level
brightness
• Tap paddle bottom to make load turn off at local ramp rate, from present brightness to full Off
• Double-tap paddle top to make load go full On quickly
• Double-tap paddle bottom to make load go full Off quickly
• Press & hold paddle top to gradually brighten load from present brightness to full On
• Press & hold paddle bottom to gradually dim load from present brightness to full Off
Button Tap / Press & Holds
Paddle Tap Double-Tap Press & Hold
Top Ramp to On-Level Fast On Brighten
Bottom Ramp to Off Fast Off Dim
Local On-Level
The Local On-Level is the brightness that the light(s) physically wired to SwitchLinc will come on at when
turned on locally. The On-Level is adjustable from off to 100% brightness. The default is 100%.
1) Use either the local buttons on your dimmer module or an INSTEON Controller to adjust the light to
the desired brightness
a. Press & hold the On button on the dimmer or Controller to brighten the light. Release at the
desired brightness.
b. Press & hold the Off button on the dimmer or Controller to dim the light. Release at the
desired brightness.