Adder Technology AdderLink iPEPS - Manual (Page 11)















0
To use a common power adapter to supply multiple iPEPS units
Available as an optional item, the Adder Power Squid cable allows you to
distribute power from an adapter to a maximum of four iPEPS units.
Note: Do not attempt to power more than two iPEPS units using the standard
5V 2A power adapter unit. For three or four iPEPS, use only the higher capacity
5V 4A adapter.
1 Connect a power output plug of the squid cable to the input socket of each
iPEPS unit.
Note: Ensure that switch 1 on each iPEPS is set to the appropriate setting for
your installation - see Power supply issues and options on the previous
page.
2 Connect the low voltage output connector from the power supply unit to
the input socket of the power spider cable.
3 Connect the IEC connector of the supplied country-specific power lead to
the socket of the power supply.
4 Connect the power lead to a nearby mains supply socket.
www
.adder
.com
LNK
100
LOC
PWR
POW
ER
REM
VNC
www
.adder
.com
LNK
100
LOC
PWR
POW
ER
REM
VNC
www
.ad der.com
LNK 100
LOC
PWR
POW
ER
REM
VNC
www
.adder
.com
LNK 100
LOC
PWR
POW
ER
REM
VNC
Input from the
power adapter
Adder Power Squid Cable