Technical data, Equipment specifications, Base station – Clear-Com BS200 User Manual
Page 37: Section 5
SECTION 5. TECHNICAL DATA
EQUIPMENT SPECIFICATIONS
Base Station
GENERAL
⎯
Frequency Range:
All, 2400 to 2483.5 MHz
Low, 2401.92 to 2439.94 MHz
High, 2443.39 to 2481.41 MHz
Frequency Response:
200 Hz to 3.5 kHz
Power Requirements:
100-240VAC, 50-60Hz or 12-14VDC
Temperature Range:
32-122°F (0-50°C)
Size:
19” x 1.72” x 17.13” (1-RU) (48.26 x 4.37 x 43.51 cm)
Weight:
9.2 lbs. (4.18 kg) maximum
# of Beltpacs per Base:
15 can be registered
Any 4 can have simultaneous full-duplex communication at one time
4-Wire I/O:
RJ45, 60
0Ω balanced, level adjustable, simultaneous operation with 2-wire
2-Wire I/O:
XLR-3M, XLR-3F, externally-switchable RTS
®
or Clear-Com
®
mode,
20
0Ω, level adjustable, null adjustable
Auxiliary Input:
XLR-3F/¼” (6.35 mm) combo jack, 60
0Ω balanced, level adjustable
Auxiliary Output:
XLR-3M, 60
0Ω balanced, level adjustable
8Ω Speaker Output:
1W into 8
Ω
Headset Connector:
4-pin mini-DIN
Electret
microphone
Headset Output:
250mW into 32
Ω
Front Panel Controls:
Power switch
Clear/Band, Reset, Unlatch and Register buttons,
IC and ISO Receive level adjustments, IC 2W/4W and 4W-Only buttons,
IC4W-Only Send and Receive level adjustments,
Auxiliary In and ISO+ buttons, Auxiliary In and Out level adjustments,
Rotary knob for volume adjustment,
Headset IC/ISO Select button and Headset Talk button
Front Panel Indicators:
Status indicator, IC and ISO Receive LEDs,
IC 2W and 4W-Only LEDs, Auxiliary In/Out LEDs,
Headset IC/ISO select LEDs, Headset PTT LED
Rear Panel Controls:
Clear-Com
®
/RTS
®
mode switch, RTS
®
Channel 1/2 switch,
2-wire channel line null adjustment
Antenna Type:
External ½ -wave dipole (R-TNC connector)
RX/TX horizontal/vertical diversity
System Distortion:
<2%
Communication Security:
64-bit encryption dual-slot diversity
TRANSMITTER
⎯
Type:
Frequency hopping, spread spectrum
Transmit Power:
100mW burst
Modulation Type:
Gaussian filtered FSK, TDM
Frequency Stability:
13 ppm
Harmonics/Spurious:
Exceeds FCC and ETSI specifications over temperature
RECEIVER
⎯
Type:
Frequency hopping, spread spectrum
RF Sensitivity:
<
−90dBm w 10
-3
BER
Frequency Stability:
13 ppm
Distortion:
<2%
32