Clear-Com BS200 - Manual (Page 22)

Register Speaker Stations
The first time you operate a WS200, you must register it for use with a specific base station. The base station
will then recognize the WS200 when its power is on, and will be able to tell the difference between it and other
electronic equipment operating on similar frequencies, or DX family Beltpacs or All-in-one Headsets.
NOTE: The WS200 must be within 6 feet (1.83 meters) of the base station while being registered.
Registration Procedure:
• Be sure the WS200 is turned off and the base station power is on.
• On the base station, press and release the REGISTER button.
⎯ The STATUS display will show a small “o” for open.
REGISTER
button
STATUS
display
• On the WS200, press and hold the ISO button while you press and release the POWER button to turn the
unit on, and then release the ISO button. This will cause the WS200 to enter the registration mode.
⎯ The STATUS display on the base station will continue to show a small “o.”
⎯ The ISO and IC lights on the WS200 will be blinking red then will change to a steady green IC light.
IC button
and light
ISO button
and light
If registration is successfully completed:
• If you have a headset plugged into the WS200 or if the speaker is on, you will hear a voice message in
the headset or speaker saying “Power on, Speaker #, Version #, Begin registration, Registration
complete…”
• After a delay of up to 15 seconds, the STATUS display on the base station will show the ID number
assigned to the WS200, for about 10 seconds.
NOTE: ID numbers are assigned sequentially to registered Beltpacs, All-in-one Headsets and Speaker
Stations as 0 thru 9, A, b, C, d and E (up to 15 total).
• The IC light on the WS200 will remain on steady green.
17