Clear-Com BS200 - Manual (Page 17)

If registration is successfully completed:
• A voice message in the headset will say “Power on, Beltpac #, Version #, Begin registration, Registration
complete, …”
• After a delay of up to 15 seconds, the STATUS display will show the ID number assigned to this Beltpac for
about 10 seconds.
NOTE: ID numbers are assigned sequentially as 0 thru 9, A, b, C, d and E.
• The power light on the Beltpac, next to the IC button, will remain on steady green.
•
Repeat Steps 1 to 3 on page 11 for each Beltpac to be registered.
If registration failed:
• A voice message in the headset will say “Power on, Beltpac #, Version #, Begin registration, …” Both
power lights on the Beltpac will be blinking red, and there may be a delay of up to 90 seconds before you
hear “Registration failed” and the STATUS display goes blank.
• Press RESET (#16) on the base station. To press RESET, insert a small paper clip or similar object into
the RESET hole at the lower-left corner of the base station front panel. When the STATUS display (#3)
becomes blank, press the REGISTER button (#17) and register the Beltpac again. If registration fails
again, call your dealer for assistance.
16 17
2 3
If you try to register more than 15 Beltpacs and/or WH200 Headsets and/or Speaker
Stations to a base station
:
• An F (for registration “Full”) will appear on the STATUS display (#3) on the base station and you will
hear “Registration failed” in the Headset.
• Clear all current registrations by pressing the CLEAR/BAND button (#2) and RESET (#16) at the same time.
To press RESET, insert a small paper clip or similar object into the RESET hole at the lower-left corner of
the base station front panel. Continue holding the CLEAR/BAND button after you release RESET, until the
clear code “c” (lower case) appears on the STATUS display.
• Register all active Beltpacs, one at a time.
Previously registered WH200 Headsets and Speaker Stations must also be re-registered.
12