Clear-Com BS200 - Manual (Page 23)

If registration failed:
• A voice message will say “Power on, Speaker, Version #, Begin registration, …”
The ISO and IC lights on the WS200 will be blinking red, and there may be a delay of up to
90 seconds before you hear “Registration failed” and the STATUS display goes blank.
• Press RESET (#16) on the base station. To press RESET, insert a small paper clip or similar object
into the RESET hole at the lower-left corner of the base station front panel. When the STATUS
display (#3) becomes blank, press the REGISTER button (#17) on the base station and register the
WS200 again. If registration fails again, call your dealer for assistance.
16 17
2 3
If you try to register more than 15 Beltpacs, WH200 Headsets or Speaker Stations:
• An F (for registration “Full”) will appear on the STATUS display (#3) on the base station and you will
hear “Registration failed.”
• Clear all current registrations by pressing the CLEAR/BAND button (#2) and RESET (#16) on the
base station at the same time. To press RESET, insert a small paper clip or similar object into the
RESET hole at the lower-left corner of the base station front panel. Continue holding the CLEAR/BAND
button after you release RESET, until the clear code “c” (lower case) appears on the STATUS display.
• Register all active Speaker Stations, one at a time.
All previously registered Beltpacs and WH200 Headsets and must also be re-registered.
18