Clear-Com BS200 - Manual (Page 18)

Set Up WH200 Headsets
Before registering them, insert a fully charged battery in each Headset,
with the metal contacts on the end of the battery inserted first. Press it
in until it snaps.
Power On/Off
• To turn power on
Press and release the power button on the inside of the Headset housing. A voice message in the earpiece
will say “Headset #” and the power light on the opposite side of the earpiece will go on.
• To turn power off
Press and hold the power button for approximately 3 seconds. A voice message in the earpiece will say
“Headset off,” and the power light on the opposite side of the earpiece will go off.
Power
button Power
light
Register WH200 Headsets
Headsets must be within 6 feet (1.83 meters) of the base station while you are registering them. Be certain the
base station power is on, and each Headset you are going to register is turned off before you begin. Headsets
that are already registered can be on or off.
NOTE: If you are setting up multiple, daisy-chained base stations, the following steps must be repeated for
Headsets being registered to each base station.
Step 1. Put the Headset on your head.
Step 2. Press the REGISTER button on the front panel of the base station (#17 on base station front panel illustration).
13
• The STATUS display (#3 on base station front panel
illustration) will show a small “o” for open.
NOTE: If you wait too long before going on to
Step 3, the base station will go out of the
registration mode and you will have to
repeat Step 2.
Step 3. Press and hold the ISO button on the Headset while you
press and release the power button to turn the unit on, then
release the ISO button. This will cause the Headset to enter
the registration mode.
17
3
• The Headset power light will begin blinking red, then will blink green two or three times and go off.
Wait! There may be a short delay.