Clear-Com HME DX300ES - Manual (Page 30)

27
FREQUENTLY ASKED QUESTIONS
Are the battery charger and base station power supplies interchangeable?
Yes.
What is the maximum recommended number of base stations that can be linked
together with interconnect cables?
Four.
Does linking the base stations automatically prevent them from interfering with each
other?
No, all bases that are linked together must be initialized or set to the high or low portion of the
frequency band to prevent them from interfering with each other’s frequencies.
If the primary base station is turned off just momentarily (before the secondary base(s)
have a chance to start working independently), will the secondary base(s) automatically
re-initialize to the primary?
Yes, the secondary base(s) will re-establish communication without being initialized again.
Will a secondary base station continue to operate if its primary is turned off for a period
of time?
Yes & No. Secondary base stations will initially stop operating when the primary base is
turned off, but will resume operation independently after about 40 seconds.
Three bars will appear in its STATUS display, and its beltpacs will still be able to communicate.
If the primary base station is turned back on, the secondary base must be turned off and on
again to re-establish proper initialization.
Can I use more than three beltpacs on a single base station in dual channel mode?
Yes, but only three users will be able to transmit at the same time.
Up to 15 beltpacs can be registered to a single base station.
Beltpacs and all-in-one headsets should be placed in push-to-talk (PTT) mode when more than
3 beltpacs or all-in-one headsets are used (See page 22).
What should I do if my carrying case and equipment get wet?
Dry them out thoroughly before further use.
Be sure all equipment is dry before using it again.
CAUTION
: Plugging wet electrical equipment into an AC power outlet is dangerous!