Clear-Com HME DX300ES - Manual (Page 16)

13
4
Press the REGISTER button on the primary base station
The STATUS window will show a small “o.”
5
Press the REGISTER button on the secondary base station
to assign it a number (1, 2 or 3).
Wait until the base is initialized (approximately 10 seconds).
6
When initialization is complete, the STATUS window will
show one bar.
7
Press the REGISTER button on the primary base station
to clear the STATUS window, or just wait and the display
will automatically go blank after timing out.
8
Repeat steps 1 – 5 to initialize up to three secondary base stations.
RECOMMENDED: If only two base stations will be used, set the secondary base
station to #2.
HINT!
Mark each base station with its assigned number, and then, when registering
beltpacs and/or all-in-one headsets, mark them with the number of the base station
they are registered to, for later identification.
NOTE: When multiple HME base stations are to be used in the Spectrum Friendly™ mode,
the primary base station should always be set to the required band first.