Clear-Com HME DX300ES - Manual (Page 13)

10
Spectrum Friendly™ Interference Avoidance
Interference such as popping sounds may occur when frequencies of a WiFi
system, a wireless DMX lighting system or another HME system is in use.
This interference may be avoided if these systems can be limited to one
portion of the 2.4GHz to 2.48GHz frequency band, and your base station is set
to operate in the opposite half of the band as follows:
1
Turn the base station power on.
The STATUS window will show “8” for a few seconds.
After the “8” disappears, the
STATUS window will be blank.
2
Press and hold the CLEAR/BAND button and, while you are still holding
the CLEAR/BAND button, press and hold the REGISTER button.
When the STATUS window shows L, H or A,
release both buttons.
3
Press the CLEAR/BAND button repeatedly to cycle through parts of the
frequency band ― L = Low end, H = High end and A = All
Stop at the desired setting and wait until “c” appears
on the STATUS display.
NOTE: Base stations are shipped in the “A” (default) position.
“c” will appear on the STATUS display if you are re-setting the frequency band.
If you change a base station’s existing frequency band setting, you will have to
re-register all beltpacs and/or all-in-one headsets that were registered to that
base station.