Clear-Com HME DX300ES - Manual (Page 12)

9
Battery sled
BAT850
Battery
AC850 Battery Charger
NOTE: Always plug base station into AC power when it is available.
Turn base station off when it is not being used, to conserve battery power.
Battery
compartment
cover
Battery
compartment
latches
NOTE: When base station battery power is low, everyone connected to or registered to that
base station will hear a tone in their headset, repeating every 8 seconds and both
headset select lights will blink.
Optional Battery Operation of Base Station
Typical base station battery life when used continuously is as follows:
Energizer Lithium 6 hours
BAT850 Rechargeable Battery 3 hours
Duracell Coppertop 1 hour
1
If you are using the battery sled, load 6 “AA” batteries into it.
2
Pull back on the battery compartment latches and lift the battery
compartment cover on the base station.
3
Insert the battery sled or rechargeable
BAT850 battery (optional) into the
battery compartment and close the cover.
4
If you are using the BAT850 battery, put it in the AC850
battery charger (optional) for recharging after each use.
Follow the instructions received with the charger.
Charging time is approximately 3 hours.