Clear-Com HME DX300ES - Manual (Page 18)

15
NOTE: Registration of all-in-one headsets is the same as the beltpac registration described
below, except for step 2.
If you have more than one base station, you must register each beltpac and/or
all-in-one headset to the base station it will be used with.
REGISTER
button
STATUS window
BELTPACS
Beltpac Registration
1
Turn the base station power on, and beltpac power off.
2
Plug the headset into the beltpac and put
the headset on your head.
3
Press the REGISTER button on the base
station registration panel.
A lower case “o” will appear on the
STATUS window.
4
Press and hold the ALL button on the
beltpac while you press and release its
PWR (power) button.
After a brief delay, you should hear
“Registration complete” in the headset.
An ID number for this beltpac will appear
briefly on the STATUS window.
5
Repeat steps 1 through 4 for each beltpac.
ALL button
Power button
NOTE: If the registration is not successful, you will hear “Registration failed.”
If this happens, refer to TROUBLESHOOTING, on page 25.
NOTE: If you try to register more than 15 beltpacs to a base station:
An “F” (Full) will appear in the STATUS window and you will hear “Registration failed” in the
headset.
Clear all current registrations by pressing and holding the CLEAR/BAND button while you
press and release the RESET button with a pen point.
Continue holding the CLEAR/BAND button after you release the RESET button until the clear
code “c” (lower case) appears on the STATUS window.
Register all beltpacs, one at a time, including previously registered beltpacs.