Clear-Com CB-222 - Manual (Page 19)

15 Tempest®24 00 MasterBelt
Pairing BeltStati ons to MasterBelt
Pair BeltStati on to MasterBelt:
Confi rm that the MasterBelt is powered ON and in Operati onal Mode (not
in Menu Mode) and that the BeltStati on is powered OFF. Confi rm that the
MasterBelt’s Network Number and Lockout Key are adjusted as needed. See the
secti on on Set Network Number and Lockout Key.
Plug one end of the pairing cable into the MasterBelt and the other end into the
BeltStati on.
The pairing cable is a standard 3.5mm
(1/8 in.) Male to Male stereo patch cord.
Turn the BeltStati on power ON by pressing and holding the BeltStati on Power ON/OFF butt on for two seconds. The pairing
process will begin automati cally. Watch for the message “Pairing Complete” to appear briefl y on the BeltStati on display.
The BeltStati on will automati cally re-initi alize.
Name MasterBelt
Name the MasterBelt with a descripti ve name. The MasterBelt name can include up to 14 characters. Prior to a name being
assigned, a hexadecimal serial number is displayed as a default.
The MasterBelt name will appear on the LCD Display, on the BeltStati on LCD display, and in the BeltStati on’s menu under
“Select Base.”
To name each MasterBelt:
1. On the MasterBelt press MENU and select “Belt Setti ngs,” then “Name BeltStati on.”
2. Rotate the Volume control to move the underscore “_” to select the character to be changed.
3. Press ENT and noti ce the underscore changes to a pointer “Λ” under the selected character.
4. Rotate the Volume control to scroll through the character list. Press ENT to select the new character. Characters always
replace and never insert. Repeat as needed.
5. Press ENT to save the new name aft er all characters are complete. Failure to press ENT to save will clear all changes.
6. Press MENU to escape to the Operati on Mode screen.
Naming the BeltStati on works the same as naming the MasterBelt.