Clear-Com ICS-1016E - Manual (Page 18)

Clear-Com Communication Systems
ICS 1008E/1016E Intercom Panel Instruction Manual
2 - 2
Figure 2-6: Matrix Frame to Panel Wiring
EXP-1016E
The installation of an EXP-1016E to a panel is simple:
1. Plug the DB-9M end of the additional key panel’s cable into the
Expansion connector on the back of a panel.
2. Plug the DB-9F end of that cable into the Panel connector on the
back of the EXP-1016E.
The pinout for the cable used to connect an ICS-1008E or ICS-1016E
to and EXP-1016 is shown in Figure 2-7. The cable should be wired
straight through i.e. pin to pin.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Matrix Frame End
Pair 2
Pair 1
Pair 3
Pair 4
ATT-T568B (Modular Jumpers Wired One to One)
1 2 3 4 5 6 7 8
Rear View of
Connector
RS-422 Receive +
RS-422 Receive -
Audio Receive +
Audio Send +
Audio Send -
Audio Receive -
RS-422 Send +
RS-422 Send -
Panel End