Clear-Com ICS-1016E - Manual (Page 12)

Clear-Com Communication Systems
ICS 1008E/1016E Intercom Panel Instruction Manual
1 - 6
2. Push (for less than 1 sec.) and quickly release the “Listen/Call”
button.
3. The button will turn bright yellow to indicate the function is on and all
the active buttons programmed with listen and/or talk with listen will
begin to flash. In addition, if the two programmable buttons (located
under the “Panel Mic” and “Listen/Call” buttons) are programmed,
they will turn from dim yellow to off.
Note: Only active talk/listen buttons programmed with listen or
talk with listen can be adjusted in listen-level mode.
4. Push the appropriate talk/listen button programmed as a listen or
talk with listen. The selected button will turn bright yellow and the
programmable buttons with the up and down arrows will turn dim
yellow.
5. Use the up and down arrows on the programmable buttons to
increase (up arrows) or decrease (down arrows) the crosspoint
volume of the selected listen or talk with listen button.
6. To exit, push the “Listen/Call” button or wait for the 3 sec. time-out.
Listen Level Reset
To reset the listen level:
1. Push (for less than 1 sec.) and quickly release the “Listen/Call”
button to activate the listen-level mode. The “Listen/Call” button will
turn bright yellow and the active talk/listen buttons programmed with
listen and/or talk with listen will flash.
2. Push and hold the “Listen/Call” button for 3 sec. to reset the listen
level settings to the default. The active talk/listen buttons
programmed with listen and/or listen with talk will stop flashing and
all the programmed talk/listen buttons will return to their previous
states.
3. Release the “Listen/Call” button.
Call Signals
To activate call signals:
1. Push and hold the “Listen/Call” button until it is bright yellow (at least
1 sec).
2. Push the talk/listen button programmed with a talk or talk with listen
of the desired destination’s label. The call signal will be sent each
time the destination’s talk/listen button is pressed.
3. The call-signal mode will time-out after 5 sec. of button inactivity or
can be deactivated by pressing the “Listen/Call” button.
Call signals can be issued to any talk or talk with listen destination
assigned to a panel’s talk/listen buttons. If more than one label is
assigned to a button, all labels will receive the signal. If a label is a
fixed group, the entire group will receive the call signal. If the label is a
party line, then every panel listening on the party line will receive the
call signal.