Clear-Com ICS-1016E - Manual (Page 13)

Clear-Com Communication Systems
ICS 1008E/1016E Intercom Panel Instruction Manual 1 - 7
Remote Telephone Line Release
This function is available only if specifically enabled in the
configuration program. To hang up a telephone interface left off the
hook:
1. Push and hold the “Listen/Call” button for at least 1 sec. to activate
the call-signal mode.
2. While holding the “Listen/Call” button, press the talk/listen button
programmed with talk or talk with listen of the desired telephone’s
label.
3. Release the “Listen/Call” button.
Note: In addition to hanging up the telephone interface, this will
deactivate any audio path set to the interface from
anywhere in the system.
Programmable Buttons
The two programmable buttons, located in the last row on the
right-hand side of the front panel, can be programmed through the
configuration program. In default mode, these programmable buttons
increase (left button) or decrease (right button) the crosspoint volume
(see “Listen/Call” on page 1-5).
The two programming modes are:
Local Exclusive
Allows the user to isolate an assigned talk/listen button by turning off
the audio paths from all other active (brightly lit) talk/listen buttons.
If a talk/listen button programmed as a talk is selected for local
exclusive, only other active talks will be turned off. If a talk/listen button
programmed as a listen is selected for local exclusive, only other
active listens will be turned off. If a talk/listen button programmed as a
talk with listen is selected for local exclusive, all other active talk/listen
buttons will be turned off.
To activate this function:
1. Push the programmable button programmed with the local exclusive
option. This will turn the button bright yellow and turn off the other
programmable button and the “Listen/Call” button.
2. Push the appropriate programmed talk/listen button. This will turn
that button on brightly and turn off all other active and/or
programmed buttons.
3. To exit this momentary-only function, release the selected talk/listen
button. All buttons will return to their previous state(s).
Note: This function does not work with the “Ans Back” button.
Local Page Override
Allows other panels to hear the user/pager through the individual
panels’ speakers regardless of their speaker on/off status or volume
level (see “Page Override Level Control” on page 1-9).