Clear-Com Eclipse-Omega - Manual (Page 31)

Clear-Com Communication Systems
Eclipse Matrix Installation Instruction Manual 4 - 1
WIRING SYSTEM
COMPONENTS
SUMMARY OF WIRING SYSTEMS
This chapter describes how to connect an Eclipse matrix to its remote
panels and interfaces and to other Eclipse matrices using fiber-optic
cable. Most panels and interfaces connect to a matrix via single 4-pair
shielded RJ-45 terminated cables.
For more detail about component placement, specifications of
individual products, and internal adjustments, refer to the individual
manual for each product. To configure panels and interfaces, refer the
Eclipse Configuration System (ECS) Manual (part 810299Z).
The following wiring topics are discussed:
• Wiring RJ-45 cables.
• Wiring an Eclipse matrix to an external computer, to a local area
network, to analog and digital intercom panels, to general-purpose
outputs, to general-purpose inputs, to an external alarm, and
directly to a 4-wire audio device.
• Using E-FIB cards to connect Eclipse Omega and Median matrices
using fiber-optic cable.
• Wiring an Eclipse matrix to the following interfaces: FOR-22 interface,
CCI-22 interface, TEL-14 interface, RLY-6 interface, and GPI-6
interface.
• Wiring an ICS panel miscellaneous connector.
• Wiring an OPT-100 auxiliary audio I/O option connector.
• Wiring an ICS panel accessory connector.
Note: Single-pair digital wiring requires double-shielded 24 AWG
conductor CAT-6E enhanced STP cable.This wiring is
discussed only in general in this manual. For more detailed
instructions, refer to the individual manual for each product.
4