Clear-Com RS-601 (No longer available) - Manual (Page 7)

R S - 6 0 1 B E L T P A C K 3
QUICK START
To start using your beltpack immediately:
1. Connect the appropriate line cables (3-pin XLR) from an
active intercom line to the beltpack.
2. Turn down the beltpack’s incoming volume with the
volume-control knob.
3. Plug in a headset equipped with a dynamic microphone to
the beltpack’s main headset jack.
The headset jack is labeled on the back of the beltpack.
4. To talk on the intercom line, press and hold the talk button.
Speak into the microphone in your headset.
Note: If you tap the talk button twice in quick succession,
the talk button locks to the “on” setting (“latches”) for
hands-free use. Press the talk button again to unlatch it.
5. Adjust the sidetone and incoming volume levels as you and
others on the intercom line speak at the anticipated levels for
the application.
6. To send a call signal, press the button labeled “call.”