Clear-Com RS-601 (No longer available) - Manual (Page 14)

1 0 R S - 6 0 1 B E L T P A C K
Once setup mode is active, if you do not select or program a feature
within five seconds, the setup mode deactivates, and the beltpack goes
back to its normal state.
See the chapter “Customizing Your Beltpack” for information on
programming your beltpack with this feature.
Computer Connector
You can program your beltpack from a computer using the V-Pack™
programming software. To use this software you must first physically
connect the beltpack to a computer with Clear-Com’s VPC-1 cable or
its equivalent.
The VPC-1 cable has a tip-ring-sleeve 3.5 mm plug at one end for
connecting to the beltpack, and a DB-9F plug at the other end for
connecting to a computer’s serial port.
To connect the VPC-1 cable from your beltpack to a computer:
1. Plug the 3.5 mm plug at one end of the cable into the beltpack’s
3.5 mm jack located just under the setup button.
2. Plug the DB-9F plug on the other end of the cable into the
DB-9M serial port socket on a computer.
If your computer only has USB connectors, you must purchase a
USB-to-serial adaptor.
Contact your dealer or the Clear-Com factory for information about
obtaining the beltpack programming kit, which contains the V-Pack
software, VPC-1 cable, and V-Pack manual. You can also find a PDF
of the V-Pack manual at www.clearcom.com.
9