Cashco SA5 User Manual
Page 8
IOM-CA5/SA5
8
Possible Causes
Remedies
A. Body bolts not torqued properly.
A1. Torque to proper value (see Section VII, F.12).
Possible Causes
Remedies
A. Contamination (debris) in regulator.
A1. Remove internals, clean and if necessary, replace regulator.
A2. Install UHP fi lter at inlet.
B. Oversized regulator; plug operates
directly next to seat.
B. Check actual fl ow conditions; resize regulator for minimum and
maximum fl ow; if necessary, replace with smaller regulator.
4.
Leakage at diaphragm fl ange.
5.
Leakage across seat.
This manual is related to the following products:
See also other documents in the category Cashco Sensors:
- 8310HP (8 pages)
- 8310HP - Differential (1 page)
- 31-N (12 pages)
- 5300P Air Filter Regulator (2 pages)
- D (8 pages)
- 1000 HP Differential (16 pages)
- HP (8 pages)
- HP-1+6+S (8 pages)
- POSR-2 (20 pages)
- 1465 (8 pages)
- 4381 (8 pages)
- DA1 (16 pages)
- DA2 - Positive Differential (16 pages)
- DA3 (16 pages)
- DA0 (12 pages)
- DAP (12 pages)
- P3 (8 pages)
- P7 (9 pages)
- P2 (8 pages)
- P4 (8 pages)
- P5 (8 pages)
- PBE-L Pressure Build Economizer (8 pages)
- MPRV-H Pressure Reducing Regulator (8 pages)
- 1000 HP Basic (12 pages)
- 1000 Cryogenic (12 pages)
- 345 (8 pages)
- POSR-1 (12 pages)
- 1000 LP (12 pages)
- P1 (8 pages)
- PBE-H Pressure Build Economizer (8 pages)
- PBE Pressure Build Economizer (8 pages)
- MPRV-L Pressure Reducing Regulator (8 pages)
- PGR-1 (16 pages)
- C-PRV (8 pages)
- C-CS (8 pages)
- 5381 (8 pages)
- SAP (12 pages)
- CA1 (12 pages)
- CA4 (12 pages)
- 8311HP (8 pages)
- 1171 (8 pages)
- 6987 (8 pages)
- 123 (8 pages)
- 123-1+6+S (8 pages)
- CA-1 (8 pages)