Cashco SA5 User Manual
Page 6
IOM-CA5/SA5
6
NOTE: If fl ang es do not come to geth er equal ly,
the upper di a phragm pres sure plate (8) may
be off-center. Remove spring cham ber (4) and
reposition upper di a phragm pres sure plate
(8) until the spring chamber (4) comes down
evenly on all sides.
11. Install all fl ange bolts (12) and nuts (11) with
nameplate (99) located under one bolt head.
Hand-tighten nuts (11).
12. Evenly tighten body bolting (11,12) using an
alternating cross pattern in one revolution
increments. Tighten all bolts to 30-35 Ft-lbs
(41-47 Nm).
This manual is related to the following products:
See also other documents in the category Cashco Sensors:
- 8310HP (8 pages)
- 8310HP - Differential (1 page)
- 31-N (12 pages)
- 5300P Air Filter Regulator (2 pages)
- D (8 pages)
- 1000 HP Differential (16 pages)
- HP (8 pages)
- HP-1+6+S (8 pages)
- POSR-2 (20 pages)
- 1465 (8 pages)
- 4381 (8 pages)
- DA1 (16 pages)
- DA2 - Positive Differential (16 pages)
- DA3 (16 pages)
- DA0 (12 pages)
- DAP (12 pages)
- P3 (8 pages)
- P7 (9 pages)
- P2 (8 pages)
- P4 (8 pages)
- P5 (8 pages)
- PBE-L Pressure Build Economizer (8 pages)
- MPRV-H Pressure Reducing Regulator (8 pages)
- 1000 HP Basic (12 pages)
- 1000 Cryogenic (12 pages)
- 345 (8 pages)
- POSR-1 (12 pages)
- 1000 LP (12 pages)
- P1 (8 pages)
- PBE-H Pressure Build Economizer (8 pages)
- PBE Pressure Build Economizer (8 pages)
- MPRV-L Pressure Reducing Regulator (8 pages)
- PGR-1 (16 pages)
- C-PRV (8 pages)
- C-CS (8 pages)
- 5381 (8 pages)
- SAP (12 pages)
- CA1 (12 pages)
- CA4 (12 pages)
- 8311HP (8 pages)
- 1171 (8 pages)
- 6987 (8 pages)
- 123 (8 pages)
- 123-1+6+S (8 pages)
- CA-1 (8 pages)