Fluid Components International ST100 Series HART - Manual (Page 12)

ST100 Series HART
8 Fluid Components International LLC
Factory Reset
WARNING
The factory Reset command re-loads the configuration and calibration
parameters that were loaded into the instrument during the original cal and
setup. Any changes made to the configuration of calibration parameters will be
lost when the Factory Reset command is executed.
ST100 Configuration
The configuration functions facilitate the setup of the individual 4 - 20 mA
current output channels.
ST100 Calibration Limits (example)
The ST100 Calibration Limits function provide you with the ability to review the
limits that have been set for each of the following process parameters: Flow,
Temperature, and Pressure.