Burkert Type 8056 - Manual (Page 13)

SE56
13
SHORT PRESSING (< 1 SECOND):
Enters/leaves the selected function
Enables the main menu for the transmitter configuration
Cancels the selected function under progress
LONG PRESSING (> 1 SECOND):
Leaves the current function, in the Quick start or Main menus.
Enables the ‘EXECUTE?’ prompt in the Main menu functions, and total reset
request (when enabled) from the required function
Confirms the selected function
SHORT PRESSING (< 1 SECOND):
Moves the cursor rightwards on the input field
Accesses to the following subject in the Quick start or Main menus
Changes the display of the process data
LONG PRESSING (> 1 SECOND):
Moves the cursor leftwards on the input field
Accesses to the previous subject in the Quick start or Main menus
SHORT PRESSING (< 1 SECOND):
Increases the numeric figure or the parameter selected by the cursor
Accesses to the previous subject in the Quick start or Main menus
Batch start/stop (when enabled)
LONG PRESSING (> 1 SECOND):
Decreases the numeric figure or the parameter selected by the cursor
Accesses to the next subject in the Quick start or Main menus
KEYPAD
BLIND CONFIGURATION
For the transmitters without keyboard (blind
configuration), the programming is made
through ISOCON (cable and software needed).
Being the housing closure dependent by the
installer, the IP degree may be compromised, so
follow the torques mentioned.
TRANSMITTER ACCESS
KEYPAD
M3
The keypad is accessible by loosening the 4 cover screws and
opening the front cover of the transmitter. Three KEYS are set
aside of the M3 power supply terminal block, allowing the user
to change display visualizations and select functions. Ensure
that the power supply cover is closed.