Burkert Type 8635 User Manual
Page 5

SETTINGS ON COMMISSIONING
SETTINGS ON COMMISSIONING
Quitting the configuration mode
Select the function
END with the
key.
Confirm the selection with the
key.
Changes to operating mode.
Setting up the process control (optio
Activating the process control (option) - Level 3
Starting the
AUTOTUNE
function
AUTOTUNE , the program for automatic parametrization of the
SIDE
Control, is started by calling up the function X:TUNE.
Using the
key, select
X.TUNE.
P.CO DBND
P.CO PARA
P.CO SETP
P.CO INP
P.CO FILT
P.CO SCAL
P.CO END
P.CO TUNE
P.C
En
pa
K
p
,
P.C
Typ
for
val
(in S/HART version only)
The function
P.CONTRL was transferred to Lev
be parametrized there as follows:
Using the
key, select
P.CONTRL.
AUTOTUNE does not parametrize the process
controller.
Display in AUTOMATIC mode (Level 1)
SETTINGS ON COMMISSIONING
Change to configuration mode (Level 2)
Hold
key depressed for 5 seconds.
Apostrophe (‘) moves from left to right
G
keypad
Menu structure
p
level
meters
p
level
meters
MATIC key
nge between manual and automatic mode
rm a parameter
(RETURN)
ct a menu item
(see also Menu Structure)
erating mode
LED flashes
D off
MANUAL/AUTOMATIC key
SETTINGS ON COMMISSIONING
ROW
down
LED (yellow)
in the MANUAL/
AUTOMATIC key
(in S/HART version only)
Using the
key, select
ADDFUNC, confirm the choice with
the
key and reach Level 3.
Using the
key, select
P.CONTRL, confirm the choice with
the
key and obtain the function
*P.CONTRL.
Using the
key, select
END and confirm the choice with the
key.
FIGURES: Each individual digit:
increment,
decrement.
Confirm ove
and each in
digit:
Level 1
Operating mode: MANUAL / AUTOMATIC
Level 2
Configuration mode:
enter operating parameters
Level 3
Supplementary menu: optional menu items
can be transferred to Level 2 by selecting
them in this level. In Level 2, these menus are
then available for parametrization.
Function item
END XXX
END XXX
Function item
END XXX
ADDFUNC
Function item
Display of the currently
running
AUTOTUNE
phase.
End of
AUTOTUNE
phase.
X.ERR X - display on occurrence of an error
X.TUNE x
X.TUNEEND
X.TUNE
flashing
Positioner
Process controller
POS:
Actual position of valve
PV:
Process value
CMD:
Setpoint position of valve
SP:
Process setpoint
INP:
Input signal for setpoint
position
POS:
Actual position of valve
Temp:
Interior temp. of device
CMD:
Setpoint position of valve
Temp:
Interior temp. of device
Display