Burkert Type 8630 User Manual

Page 6

SETTINGS ON COMMISSIONING

MANUAL or AUTOMATIC mode

Changing the internal set-point
(process controller only)

In AUTOMATIC mode:

Press the

key or

key for 3 seconds.

Set the process set-point with the

key or

key.

Confirm the entry with the

key and return to the operating mode.

These and all other software functions are
described in detail in the operating instructions for
the TOP

Control Continuous Type 8630 (on

the supplied CD).

In the 1

level you can change over between the MANUAL and the

AUTOMATIC mode by pressing the

Exiting the CONFIGURATION MODE

Select the function

END with the

key.

Confirm the selection with the

key.

Changeover to the operating mode takes place.

Setting up the process control (option) - Level 2

l 3

with the

key.

g the

COUNT:

Each individual place:

increment,

decrement.

Confirm total
value, also each
individual place:

P.CO DBND

P.CO PARA

P.CO SETP

P.CO INP

P.CO FILT

P.CO SCAL

P.CO END

P.CO TUNE

P.CO PARA
Input of the PID
controller
parameters
K

, T

u. X0

(operating point)

P.CO INP
Type of signal of
the process
actual value
preselection

The function

P.CONTRL has been shifted to the 2

level and can

be parametrized there as follows:
Select

P.CONTRL. with the

key.

UTOTUNE

ough the

rom 5 to 0

the currently

OTUNE

Functions

MANUAL mode

AUTOMATIC mode

Opening the valve

The valve regulates
according to the
set-point
preselection.

Closing the valve

Hold the up key pressed and
simultaneously press the down key:
Opening in rapid speed

Hold the down key pressed and
simultaneously press the up key:
Closing in rapid speed

Opeerating
mode

Yellow LED

Display

AUTOMATIC

flashes

Inverted comma moves from left

to right (for further indications see

Indications in AUTOMATC-mode)

MANUAL

off

The last indication set in
AUMTOMATIC mode is displayed.