Burkert Type 8605 User Manual
Page 26

26
Serial Communication
command error
Error code
0x02
Error name
invalid_selection
description
An invalid data range was selected.
Error code
0x03
Error name
parameter_too_large
description
Transfer parameter too large. It may be a table or array index from the data range, i.e. an
incorrect value range.
Error code
0x04
Error name
parameter_too_small
description
Transfer parameter too small. It may be a table or array index from the data range, i.e. too low
for the value range.
Error code
0x05
Error name
too_few_data_bytes
description
Not enough data bytes were received.
Error code
0x07
Error name
write_protected
description
device is write-protected.
Error code
0x10
Error name
access_restricted
description
The command that was sent cannot be executed (currently). Access was denied. The cause
could be, for example, that the necessary access rights are lacking or the command is not
permitted in the current operating mode.
Error code
0x40
Error name
no_command
description
Invalid/incorrect command, i.e. the command that was received is not supported by the
device.
Error messages - First status byte - Command error
Table 16:
english
Typ 8605