Xoro HSD 4000 - Manual (Page 96)

Connecting to a TV
Connecting to a stereo TV set
Notes:
l Choose below speaker size setting in the setting “Audio” menu if you use the TV speakers: Front:
Large, Center/Rear/Subwoofer: Off. At this setting situation which is Stereo effect, the signal from
Audio output L, R is the same as the FL & FR output, also same as the audio signal from Scart jack.
l Only one kind of connection to the TV set can be made. If your TV set doesn’t support “Y Pb Pr”
function, don’t switch the VIDEO OUT to Y Pb Pr of the unit, otherwise there will be no picture
output.
l Consumers should note that not all high definition television sets are fully compatible with this
product and may cause artefacts to be displayed in the picture. In case of 525 or 625 progressive
scan picture problems, it is recommended that the user switch the connection to the ‘standard
definition’ output.
BASIC CONNECTIONS
l Ensure that the power switch of this unit and other equipment to be connected is turned off before
commencing connection
l Read through the instructions before connecting other equipment
l Ensure that you observe the color-coding when connecting audio and video cords
l Please use only one kind of connection with TV set for the unit and choose correct video output
setting, otherwise there may be image distortion.
To get better viewing quality, you are advised using S-video cord to connect the TV set with S-video
input meanwhile changing the TV set to S-video input format.
The TV set with Y, Cb, Cr input can get more clear picture and realistic image when it connects to Y, Cb,
Cr output jacks of this player. The Video out setting must be set as YUV if you use Y, Cb, Cr output.
If your TV has “Y Pb Pr” function (progressive scan function), you can use this unit’s progressive scan
output by using Y Pb Pr output jacks & setting the player’s VIDEO OUT as Y Pb Pr.
AUDIO OUTPUT (LEFT)
AUDIO OUTPUT (RIGHT)
DVD player
TV
Component Video Output
96