Start up & warranty form – ClimaCool IOM FLEX SERIES User Manual
Page 29
www.climacoolcorp.com
®
27
Start Up & Warranty Form
Start-Up Water Cooled Rev0807
Project Name:
_________________________________ Start-Up Date: __________________
Address: __________________________________
__________________________________
Module #:
______________ Model #: ____________
Serial Number: __________________
Chiller # _______ Bank # _________ On-Site Location: _________________________
Evaporator entering pressure _______ Evaporator leaving pressure _______ Δ P_______
Condenser entering pressure _______ Condenser leaving pressure _______ Δ P_______
Evaporator & condenser “flow devices” shut off chiller below aprox. 25% loss of flow _________
Water Samples taken (Mark “X”) Evaporator ___ Condenser _____
Water sample bottles are provided. Follow instructions on label and mail same day sample is taken.
All wiring terminations in module panel, safeties and compressors tightened _____
Voltage / Ground L1 ________ L2 ________ L3 ________
Phase / Phase L1/ L2 ________ L2/ L3 ________ L1/ L3 ________
Circuit # 1
Amperage
L1 ________ L2 ________ L3 ________
_
_
_
_
_
l
e
v
e
L
l
i
O
s
s
a
l
G
t
h
g
i
S
___ Comments: _____________________
Suction Pressure ________ _______________________________
Suction Temperature ________ _______________________________
Discharge Pressure ________ _______________________________
Compressor Superheat ________ _______________________________
Evaporator Entering Water Temperature ________ _______________________________
Evaporator Leaving Water Temperature ________ _______________________________
Condenser Entering Water Temperature ________ _______________________________
Condenser Leaving Water Temperature ________ _______________________________
Evaporator Pressure Differential ________ _______________________________
Condenser Pressure Differential ________ _______________________________
2
#
t
i
u
c
ri
C
Amperage
L1 ________ L2 ________ L3 ________
_
_
_
_
_
l
e
v
e
L
l
i
O
s
s
a
l
G
t
h
g
i
S
___ Comments: _____________________
Suction Pressure ________ _______________________________
Suction Temperature ________ _______________________________
Discharge Pressure ________ _______________________________
Compressor Superheat ________ _______________________________
Evaporator Entering Water Temperature ________ _______________________________
Evaporator Leaving Water Temperature ________ _______________________________
Condenser Entering Water Temperature ________ _______________________________
Condenser Leaving Water Temperature ________ _______________________________
Evaporator Pressure Differential ________ _______________________________
Condenser Pressure Differential ________ _______________________________
Verify Safety Settings: Low Limit____ High Pressure Limit ____Low Pressure Limit ____
NOTE: Correct rotation of scroll compressors is extremely critical. Incorrect rotation could damage the compressor.
Contractor Name: ___________________________ __________________________________
Address: ___________________________
(Authorized Signature)
___________________________
Phone: ___________________________ Date: _____________________________
Start-Up and Warranty Registration Form
(Water-Cooled)
Sign & date and fax: (405) 745-2072 Attn.: Vivian Doyle / Dennis Megaro
Or E-mail:
T H E U L T I M A T E C H I L L E R S O L U T I O N
®
®