ClimaCool UCW_H 30, 50, 70, 85 - Manual (Page 4)

www.climacoolcorp.com
2
Pre-Installation
Inspection
Upon receipt of equipment, carefully check the shipment
against the bill of lading and inspect each chiller for any
damage incurred during shipment . Thoroughly check for
any visible damage of control panels and electrical
and/or refrigeration components or broken copper lines .
The carrier must make proper notation of any damages or
shortages on all copies of the bill of lading and complete
a common carrier inspection report prior to your final
acceptance of the shipment . Note: It is the responsibility
of the purchaser to file all necessary claims with the
carrier . In addition, please notify the ClimaCool Customer
Service Department at 405 .815 .3000 or customerservice@
climacoolcorp .com of all damage immediately .
Storage
Chillers should be stored in an upright position and kept in a
clean, dry area .
Handling of Modules
Carefully remove the module’s packaging . The chiller’s steel
base cutouts provide maneuverability by forklift or pallet
jack into its final position (See Rigging and Lifting Procedures
on page 7) . Verify that all header grooved couplings and
mounting hardware kits are on site prior to connecting
the modules . Note: Consult factory for handling other than in
the upright position .
Rigging and Lifting
Each module should be lifted using a pallet jack or fork
lift . If it is necessary to utilize a crane for rigging or lifting,
each module shall be lifted using lifting straps and spreader
bars using rigging points identified on Rigging and Lifting
Procedures on page 7 .
Warranty
To ensure proper equipment longevity, design performance
and reliability, all ClimaCool chillers must be installed,
operated and maintained in accordance with ClimaCool IO&M
manuals . Water quality is of the utmost importance for the
proper care and maintenance of your modular chiller system .
Regular treatment of the water will increase longevity of your
system . Failure to provide adequate filtration or treatment
of evaporator and condenser water will void the ClimaCool
module’s warranty. A factory authorized technician is
required to perform the startup of your ClimaCool chiller .
Please contact the ClimaCool Customer Service Department
at 405-815-3000 or customerservice@climacoolcorp .com to
schedule . There is a minimum of 3 weeks’ notice required to
schedule your factory startup.