CEMB USA C73-L SE (B) - Manual (Page 15)

15
FI FE
Use and maintenance manual Rev. 09-2009
ENGLISH
Balancing spin.
INDICATION
If the machine remains on this screen without being
used for more than the time preset in the Setup
parameters, the screen automatically returns to the
screen-save.
5.4.1 Indication of exact correction weight
position
It is possible use this function in the event of correction of
the external side using an adhesive weight placed inside
the rim. Remember to thoroughly clean the application
areas. This function allows cancelling approximations in
the mounting of counterweights with consequent reduction
of the residual unbalance.
From the measurement results
frame:
▪ Press button from the Measurements screen.
▪ Pull out the rim distance+diameter gauge in position A,
fi gure in STANDARD WHEELS . Approach of the weight to
the correction position is indicated by a moving coloured
arrow [
].
▪ When a fi xed arrow [ ] is reached, rotate the wheel to
correction position (FI or FE) and apply the counterweight
by turning the tip of the gauge towards the outside, into
the position in which the pincers touches the wheel.
Compensation is made for the fact that the weight appli-
cation position is no longer at 12 o’clock (where appro-
priate use the weight pusher).
INDICATION
when the acoustic signal is enabled ( ACOUSTIC
SIGNAL), the reaching of a fixed arrow [ ] is
accompanied by a “beep”.
5.4.2 “SPLIT” control
SPLIT is only possible in the event of static unbalance or
ALUS external side and is used to hide any adhesive weights
correcting unbalance behind the rim spokes.
To split the unbalance detected in two different positions,
proceed as follows :
Position static unbalance or ALUS external side in 1.
the correction position :
Select a spoke close to the 12 o’clock postion to be 2.
corrected, more it into the 12 o’clock position and
press button [6].
Turn the wheel in the rotation direction indicated on
3.
the unbalance display, brining the second spoke to
the 12 o’clock position and press button [6].
Turn the wheel in direction of rotation.
Turn the wheel in reverse direction of rota-
tion.
At this stage, the screen shows the graphic display 4.
of the correction spokes with the relative weight of
the unbalance detected.
Position the spokes indicated on screen in the 12
5.
o’clock position and correct with the value displayed.
Any error in this procedure is clearly shown on screen.
Always follow the information provided by the wheel to opti-
mise correction.
When SPLIT is enabled, the icon appears
on the left of the screen.
Use of the wheel balancer