J&M GC-31T Assembly - Manual (Page 8)

GC31
t
-1 G
rain
C
art
a
ssembly
-8-
STEP - 14
STEP - 13
Attach rear rail cross brace. Use (21) M10 serrated flange hex head bolts and (21) M10 serrated hex
flange nuts. Do nOt insert bolts into holes that are surrounded by squares in the figure above.
Attach the two AS Slope Gussets and two OAS Slope Gussets using (12) 8.8 M10 x 25 MM serrated
flange hex head bolt and M10 serrated flange hex head nuts.
!STOP! It is important to have all bolts and nuts tightened at this point. In the next steps, it will become
hard to access some of the bolts.