Neff T66S66N0 - Manual (Page 11)

Operating the electric hob with double
hotplate
Models equipped with a ceramic hob are dual circuit
hobs and therefore include two hotplates, a central
700 W hotplate and another complete 1800 W
hotplate, if your appliance operates on 230 V.
Switching on
and off
The small hotplate (central hotplate), is switched
on by turning the control clockwise to setting 0 to
unlock it, after which the control can be positioned
Setting 1: low power.
Setting 9: full power.
If you also want to use the extendable hotplate, the
and then positioned to setting 9 (maximum heat
setting) or set to any other intermediate setting for
lower heat levels. To use the small hotplate again,
turn the control anticlockwise to setting 0, and
switch on again.
Switching on
The residual heat/operating indicator light will go out
once the surface of the hob has cooled down. Switching off
It is recommended to start cooking on full power
and then to use the intermediate settings after a few
minutes.
Do not allow liquids to be spilt on the surface of the
electric hob.
Do not cook with wet pans.
Note
10
Fig. 6
Fig. 6a
to any of the settings marked from 1 to 9. Fig. 6:
control must be turned beyond setting 9 (Fig. 6a)