26 configuration track map sensor requirements – MoTeC ADL3 EDL3 User Manual
Page 30
26 Configuration
Track Map Sensor Requirements
In order for the i2 Data Analysis software to plot a track map the following
sensors are required and must be logged.
• Lateral G force (internal sensor)
• Wheel
Speed
• Lap Beacon (the ‘Beacon’ Channel must be logged)
• Optionally
Longitudinal
G force (internal sensor)
A Longitudinal G force sensor should be used if the vehicle has only one
wheel speed sensor. This allows the analysis software to eliminate wheel
lockups which is essential when creating or using a track map.
See also other documents in the category MoTeC Hardware:
- ADR (25 pages)
- ACL VIM (99 pages)
- ADL EDL (81 pages)
- ADL2 EDL2 (82 pages)
- AFM1 (20 pages)
- BR2 BTX (47 pages)
- BRX (21 pages)
- C125 (89 pages)
- C185 (85 pages)
- CDL3 (86 pages)
- DBW-4 (21 pages)
- Display Creator (66 pages)
- E888 (30 pages)
- GPS-BL1 (8 pages)
- GPS-G1 (7 pages)
- GPS-L5 (8 pages)
- Interpreter (37 pages)
- Knock SKM (36 pages)
- LTC (39 pages)
- M1 Series Quick Start Guide (1 page)
- M1 Tune User Manual (77 pages)
- M4 (63 pages)
- M400 (101 pages)
- M84 (86 pages)
- MDC (22 pages)
- MDC2 (20 pages)
- MDD (48 pages)
- PDM16 (61 pages)
- PLM (59 pages)
- PWC Plug-In ECU (91 pages)
- Screwdriver ECU (5 pages)
- SDC3 (24 pages)
- SDL (70 pages)
- SDL3 (76 pages)
- Snowmobile Plug-In ECU (46 pages)
- VCS (36 pages)