DE-STA-CO PN500 - Manual (Page 32)

30
SECTION 8: Repair and Replace (continued)
FOLLOWER NO. FM-50; FM-62; FM-75
FIGURE 16
DISASSEMBLY:
Remove jam nut, setscrew, follower and nylon plug.
ASSEMBLY:
Clean the follower stud hole in the hub and inspect for an out-of-round condition, which could cause
backlash by failing to support the stud at the top.
Apply a light coat of assembly grease to a new cam follower and install it firmly against seat; loosen
and retighten. Install new nylon plug and tighten setscrew and jam nut in place.
SOCKET HEAD
SET SCREW
(Cup or Dog Point)