DE-STA-CO PN500 - Manual (Page 19)

17
SECTION 4: Installation (continued)
4.2.5. Dowel Clutch Adapter to PN300 Output
4.2.5.1. Drill and ream through clutch into Indexer output at (2) drilled holes put
into Indexer in Step 1b for a press fit with .375 diameter dowel pins (2)
places. (See Figure 11)
NOTE: Holes in clutch housing body will have one end machined
for press fit with dowels for another application. End of hole may
be enlarged with a clearance drill for easier assembly.
WARNING: IF REQUIRED, DISASSEMBLE RT6-D AND CLEAN ALL
PARTS TO REMOVE METAL CHIPS AND BURRS. CLUTCH IS NOT
SEALED, AND METAL CHIPS, ETC., BETWEEN ROTATING PARTS
CAN CAUSE CLUTCH TO FAIL.
CHECK OPERATION OF CLUTCH BY MANUALLY ROTATING THE
DIAL TO TRIP THE CLUTCH AND RE-ENGAGE IT IN BOTH
DIRECTIONS.
FIGURE 11
DOWEL CLUTCH ADAPTER TO PN300 OUTPUT