DE-STA-CO PN500 User Manual
Page 12
10
SECTION 4: Installation
These units are manufactured to meet a specific set of design parameters. Any change to the load,
dials, or speed of the camshaft may require a size change. No change can be made without affecting
other performance characteristics of the unit and, therefore, should not be done without consulting
the factory.
4.1.
To install the unit:
4.1.1. Rotate camshaft so cam is in center of dwell (see figure 5 and 6).
FIGURE 5 - PINNACLE SERIES
FIGURE 6 - ED SERIES