Atec Tektronix-AWG7000 Series - Manual (Page 6)

Data Sheet
Main Arbitrary Waveform Output
Characteristic AWG7102 AWG7101 AWG7052 AWG7051
Digital to Analog Converter
Resolution 10 bit (no marker output) or 8 bit (2 ch markets available): each channel selectable
Standard Output (into 50 Ω)
Number of arb outputs 2 1 2 1
Output style Differential
Output impedance 50 Ω
Connector SMA Front
Amplitude
Amplitude
Normal 50 mV
p-p
to 2.0 V
p-p
Direct 50 mV to 1.0 V
p-p
Resolution 1 mV
DC accuracy ±(3.0% of Amplitude + 2 mV) at offset = 0 V
Offset
Range
Normal -0.5 V to +0.5 V
Direct N/A
Resolution 1 mV
Accuracy ±(2% of offset ±10 mV) at minimum amplitude
Pulse response (-1 and 1 waveform data, 0 V offset, through filter at 1 V
p-p
)
Rise/Fall Time (20 to 80%)
Normal 350 ps (at 2 0 V
p-p
)
Direct 75 ps (at 1.0 V
p-p
)
Overshoot Less than 10% (at 1.0 V
p-p
amplitude)
Bandwidth (-3 dB) (typical)
Normal 750 MHz
Direct 3.5 GHz
Timing skew Less than 20 ps (Direct output; between each channel (+) Pos and (–) Neg output)
Low-pass filter
Normal 50 MHz, 200 MHz (Bessel type)
Direct N/A
Delay from marker output Normal: 50 MHz (9.7 ns), 200 MHz (3.9 ns), Through (2.1 ns), Direct (0.5 ns)
Sine wave (up to 5th harmonic) (10 GS/s clock, 32 waveform points, 312.5 MHz signal
frequency, 1.0 V amplitude)
(5 GS/s clock, 32 waveform points, 156.25 MHz signal
frequency, 1.0 V amplitude)
Harmonic distortion (typical)
Normal ≤ -35 dBc ≤ -40 dBc
Direct ≤ -42 dBc ≤ -45 dBc
Nonharmonic spurious (typical)
Normal ≤ -50 dBc (DC to 5 GHz) ≤ -50 dBc (DC to 2.5 GHz)
SFDR (typical) (10 GS/s clock, Amplitude: 1 V
p-p
, Offset: 0 V, filter: “through,”
10 bit DAC operation mode, DC to 5 GHz)
(5 GS/s clock, Amplitude: 1 V
p-p
, Offset: 0 V, filter: “through,”
10 bit DAC operation mode, DC to 2.5 GHz)
Normal 45 dB 51 dB
Direct 45 dB (at 312.5 MHz) 51 dB (at 156 MHz)
Phase noise (10 GS/s clock, Amplitude: 1 V
p-p
, Offset: 0 V, 312.5 MHz)
≤ -90 dBc/Hz at 10 kHz offset
(5 GS/s clock, Amplitude: 1 V
p-p
, Offset: 0 V, 156 MHz)
≤ -90 dBc/Hz at 10 kHz offset
Random Jitter (typical) 1010 clock pattern
RMS
Normal 1.6 ps 1.6 ps
Direct 0.9 ps 0.9 ps
Total Jitter (typical) 2 15 -1 PN data pattern (at 10-12 BER)
Peak-to-Peak
Normal 50 ps at 0.5 Gb/s 50 ps at 0.5 Gb/s
Direct 30 ps at 1 to 6 Gb/s 30 ps at 1 to 5 Gb/s
6 www.tektronix.com