Atec Rohde-Schwarz-FSH-Z1 - Manual (Page 3)

Version 08.00, June 2011
Rohde & Schwarz R&S ® FSH4/FSH8 Spectrum Analyzer 3
Specifications
Specifications apply under the following conditions:
15 minutes warm-up time at ambient temperature, specified environmental conditions met, calibration cycle adhered to.
Data without tolerances: typical values only. Data designated as “nominal” applies to design parameters and is not tested. Data
without tolerance limits is not binding.
Frequency
R&S ® FSH4 model .04/.14 9 kHz to 3.6 GHz
R&S ® FSH8 model .08/.18 9 kHz to 8 GHz
R&S ® FSH4 model .24 100 kHz to 3.6 GHz
Frequency range
R&S ® FSH8 model .28 100 kHz to 8 GHz
Frequency resolution 1 Hz
Reference frequency, internal
Aging per year
1 × 10 –6
0 °C to +30 °C 1 × 10 –6 Temperature drift
+30 °C to +50 °C 3 × 10 –6
Achievable initial calibration accuracy 5 × 10 –7
Total reference uncertainty (time since last adjustment × aging rate) +
temperature drift + calibration accuracy
Reference frequency, with R&S ® HA-Z240 GPS receiver option
GPS ON, ≥ 1 minute after satellite lock ±2.5 × 10 –8 Frequency uncertainty
up to 30 minutes after losing satellite lock ±5 × 10 –8
Frequency readout
Marker resolution
0.1 Hz
Uncertainty ±(marker frequency × reference
uncertainty + 10 % × resolution bandwidth
+ ½ (span / (sweep points – 1) + 1 Hz)
Number of sweep (trace) points 631
Marker tuning frequency step size span/630
Frequency counter resolution 0.1 Hz
Count uncertainty SNR > 25 dB ±(frequency × reference uncertainty +
½ (last digit))
Frequency span 0 Hz, 10 Hz to 3.6/8 GHz
Span uncertainty nominal 1 %
Spectral purity SSB phase noise f = 500 MHz
30 kHz < –95 dBc (1 Hz), typ. –105 dBc (1 Hz)
100 kHz < –100 dBc (1 Hz), typ. –110 dBc (1 Hz)
Carrier offset
1 MHz < –120 dBc (1 Hz), typ. –127 dBc (1 Hz)
Sweep time
span = 0 Hz 200 µs to 100 s
10 Hz ≤ span ≤ 600 MHz 20 ms to 1000 s
Sweep time
span > 600 MHz 20 ms × span/600 MHz to 1000 s
span = 0 Hz nominal 1 % Uncertainty
span ≥ 10 Hz nominal 3 %