Atec EXFO-FTB-8120-8130NGE - Manual (Page 12)

FTB-8120NGE/8130NGE Power Blazer
ETHERNET ADD/DROP INTERFACE
10/100/1000 Base-T (Add/Drop) Compliance 10 Mbit/s: IEEE 802.3 section 14
100 Mbit/s: IEEE 802.3 section 25
1000 Mbit/s: IEEE 802.3 section 40
Connector RJ-45 Ethernet
Gigabit Ethernet (Add/Drop) Interface/connector SFP/Dual LC
Compliance 1000 Mbit/s: IEEE 802.3 Section 40 a
Wavelength/Max Tx level 850, 1310 nm/—3 dBm
1550 nm/+5 dBm
REF-OUT INTERFACE
Parameter Value
Tx pulse amplitude 600 ± 150 mVpp
Transmission frequency
Clock divider = 16
Clock divider = 32
Clock divider = 64
SONET/SDH/10 GigE WAN
622.08 MHz
311.04 MHz
155.52 MHz
10 GigE LAN
644.53 MHz
322.266 MHz
161.133 MHz
OTU2
669.33 MHz
334.66 MHz
167.33 MHz
OTU1e
690.57 MHz
345.29 MHz
172.64 MHz
OTU2e
693.48 MHz
346.74 MHz
173.37 MHz
OTU1f
704.38 MHz
352.19 MHz
176.10 MHz
OTU2f
707.35 MHz
353.68 MHz
176.84 MHz
Output configuration AC coupled
Load impedance 50 ohms
Maximum cable length 3 meters
Connector Type SMA
SONET/SDH AND OTN OPTICAL INTERFACES
OC-3/STM-1 OC-12/STM-4 E2/8M OC-192/STM-64/OTU2
15 km;
1310 nm
40 km;
1310 nm
40 km;
1550 nm
80 km;
1550 nm
15 km;
1310 nm
40 km;
1310 nm
40 km;
1550 nm
80 km;
1550 nm
15 km;
1310 nm
40 km;
1310 nm
40 km;
1550 nm
80 km;
1550 nm
10 km;
1310 nm
40 km;
1550 nm
80 km;
1550 nm
Tx level
–5 to
0 dBm
–2 to
3 dBm
–5 to 0
dBm
–2 to
3 dBm
–5 to
0 dBm
–2 to
3 dBm
–5 to
0 dBm
–2 to
3 dBm
–5 to
0 dBm
–2 to
3 dBm
–5 to
0 dBm
–2 to
3 dBm
–6 to
–1 dBm
–1 to
2 dBm
0 to
4 dBm
Rx operating range
–23 to
–10 dBm
–30 to
–15 dBm
–23 to
–10 dBm
–30 to
–15 dBm
–22 to
0 dBm
–27 to
–9 dBm
–22 to
0 dBm
–29 to
–9 dBm
–18 to
0 dBm
–27 to
–9 dBm
–18 to
0 dBm
–28 to
–9 dBm
–11 to
–1 dBm
–14 to
–1 dBm
–24 to
–9 dBm
Transmit bit rate 155.52 Mbit/s ± 4.6 ppm 622.08 Mbit/s ± 4.6 ppm 2.48832 Gbit/s ± 4.6 ppm
2.66606 Gbit/s ± 4.6 ppm (OTU1)
9.95328 Gbit/s ± 4.6 ppm
(OC-192/STM-64)
10.70922 Gbit/s ± 4.6 ppm (OTU2)
11.0491 Gbit/s ± 4.6 ppm (OTU1e)
11.0957 Gbit/s ± 4.6 ppm (OTU2e)
11.2701 Gbit/s ± 4.6 ppm (OTU1f)
11.3176 Gbit/s ± 4.6 ppm (OTU2f)
9.95328 Gbit/s ± 4.6 ppm
10.70922 Gbit/s ± 4.6 ppm
(OTU2)
Receive bit rate 155.52 Mbit/s ± 100 ppm 622.08 Mbit/s ± 100 ppm 2.48832 Gbit/s ± 100 ppm
2.66606 Gbit/s ± 100 ppm (OTU1)
9.95328 Gbit/s ± 100 ppm
(OC-192/STM-64)
10.70922 Gbit/s ± 100 ppm (OTU2)
11.0491 Gbit/s ± 120 ppm (OTU1e)
11.0957 Gbit/s ± 120 ppm (OTU2e)
11.2701 Gbit/s ± 120 ppm (OTU1f)
11.3176 Gbit/s ± 120 ppm (OTU2f)
9.95328 Gbit/s ± 100 ppm
10.70922 Gbit/s
± 100 ppm (OTU2)
Operational
wavelength range
1261 to
1360 nm
1263 to
1360 nm
1430 to
1580 nm
1480 to
1580 nm
1270 to
1360 nm
1280 to
1335 nm
1430 to
1580 nm
1480 to
1580 nm
1260 to
1360 nm
1280 to
1335 nm
1430 to
1580 nm
1500 to
1580 nm 1290 to 1330 nm
1530 to
1565 nm
1530 to
1565 nm
Spectral width 1 nm (–20 dB) 1 nm (–20 dB) 1 nm (–20 dB) 1 nm (–20 dB)
Frequency offset generation ±50 ppm ±50 ppm ±50 ppm ±50 ppm b
Measurement
uncertainty (accuracy)
Frequency ±4.6 ppm ±4.6 ppm ±4.6 ppm ±4.6 ppm
Optical power ±2 dB ±2 dB ±2 dB ±2 dB
Maximum Rx before damage c 3 dBm 3 dBm 3 dBm 3 dBm
Jitter compliance GR-253 (SONET)
G.958 (SDH)
GR-253 (SONET)
G.958 (SDH)
GR-253 (SONET)
G.958 (SDH)
G.8251 (OTN)
GR-253 (SONET)
G.825 (SDH)
G.8251 (OTN)
Line coding NRZ NRZ NRZ NRZ
Eye safety SFP/XFP transceivers comply with IEC 60825 and 21 CFR 1040.10 (except for deviations pursuant to Laser Notice No. 50, dated July 2001), for Class 1 or 1M lasers.
Connector d Dual LC Dual LC Dual LC Dual LC
Transceiver type e SFP SFP SFP SFP
Notes
a. SFP/XFP transceivers comply with IEC 60825 and 21 CFR 1040.10 (except for deviations pursuant to Laser Notice 50, dated July, 2001), for Class 1 or 1M lasers.
b. For OTU1e, OTU2e, OTU1f and OTU2f rates, the frequency offset generation is ±115 ppm.
c. In order not to exceed the maximum receiver power level before damage, an attenuator must be used.
d. External adaptors can be used for other types of connectors. For example FC/PC.
e. SFP/XFP compliance: The FTB-8120NGE/8130NGE selected SFP/XFP shall meet the requirements stated in the “Small
Form-Factor Pluggable (SFP) Transceiver Multisource Agreement (MSA)”. The FTB-8120NGE/8130NGE selected SFP/XFP
shall meet the requirements stated in the “Specification for Diagnostic Monitoring Interface for Optical Xcvrs”.
SonEt/Sdh and otn oPtical intErfacES
ElEctrical intErfacES (cont’d)
The following section provides detailed information on all supported SONET/SDH/OTN optical interfaces.