Atec Fluke-DSP-2000 - Manual (Page 97)

Running Individual Tests
Monitoring Impulse Noise
4
4-21
Running the Impulse Noise Test
The connector type for the noise test is always RJ45. The noise test is not valid for
coaxial cable because the level of noise on coaxial cable is negligible.
To monitor impulse noise, refer to Figure 4-6 and proceed as follows:
RJ45
Jack
Wall Outlet
Patch Panel
2 Meters
Test Tool
2 Meters
ENTER
TEST
FAULT INFO
EXIT
SAVE
1 2 3 4
OFF
PRINT
MONITOR
SETUP
SPECIAL
FUNCTIONS
SMART
REMOTE
SINGLE TEST
AUTO
TEST
WAKE UP
DSP-2000 CABLE ANALYZER
Smart
Remote
OFF
ON
DSP-2000SR SMART REMOTE
PASS
TESTING
FAIL
LOW BATTERY
gc24f.eps
Figure 4-6. Connections for Monitoring Impulse Noise (Model DSP-2000 Shown)