Atec Fluke-DSP-2000 - Manual (Page 42)

DSP-100/2000
Users Manual
2-26
Selecting a Length Unit
The test tool displays length measurements in meters or feet.
To change the unit of measurement, proceed as follows:
1. Turn the rotary switch to SETUP.
2. Press
$Page Down four times.
3. Press
! Choice.
4. Use
D U to highlight the desired unit.
5. Press
E to accept the highlighted unit.
Selecting a Numeric Format
The test tool displays decimal fractions with a decimal point separator (0.00) or a
comma separator (0,00).
To change the numeric format, proceed as follows:
1. Turn the rotary switch to SETUP.
2. Press
$Page Down four times.
3. Use
D to highlight the numeric format.
4. Press
! Choice.
5. Use
D U to highlight the desired format.
6. Press
E to accept the highlighted format.