Atec Fluke-DSP-2000 - Manual (Page 12)

DSP-100/2000
Users Manual
1-2
•
Produces 2-way Autotest results in approximately 20 seconds.
•
Includes a stored library of common test standards and cable types.
•
Allows for configuration of up to 4 custom test standards.
•
Time Domain Crosstalk (TDX

) analyzer locates the position of crosstalk
(NEXT) problems on a cable.
•
Tests for return loss (RL).
•
Produces plots of NEXT, attenuation, ACR, and RL. Shows NEXT, ACR, and
attenuation results up to 155 MHz.
•
Stores at least 500 cable test results in nonvolatile memory.
•
Monitors impulse noise and network traffic on Ethernet systems. Hub port
locator helps you identify port connections.
•
Sends stored test reports to a host computer or directly to a serial printer.
•
Flash EPROM accepts test standard and software upgrades.
•
Tests fiber optic cable when used with a Fluke DSP Fiber Optic Meter.
Model DSP-2000 includes the following additional features:
•
Monitors 100BaseTX network traffic.
•
Diagnostic routine provides specific information about the location and cause
of an Autotest failure.
•
Tests for remote return loss (RL@REMOTE) and power sum NEXT
(PSNEXT).
•
Determines which standards are supported by a hub port connection.
•
Tone generator lets you use an inductive pickup device to identify cables in a
LAN installation.