Atec Agilent-81180A - Manual (Page 19)

19
External sample clock input
Characteristics Description
General External signal is fed to a frequency splitter. Same frequency is applied to both channels.
Connector type Rear-panel SMA
Input impedance 50 Ω, typical
Input voltage swing 0 dBm to 10 dBm
Input frequency range 2.0 GHz to 4.2 GHz
Clock divider 1/1, 1/2, 1/4, … 1/ 256, separate for each channel
Damage level 15 dBm
Two-instrument synchronization
Characteristics Description
General Two instruments are synchronized via dedicated synchronization cable.
Master instrument controls waveform generation of slave instrument.
Initial skew between
instruments
20 ns + 0 to 16 SCLK periods
Offset control 8 SCLK periods increments
Clock source Master sample clock generator
Trigger source Master trigger input
Display
Characteristics Description
Type TFT LCD, back-lit
Size 4 “
Resolution 320 x 240 pixels
Peripheral devices
Characteristics Description
USB port 1 x front, USB host, standard A; 1 x rear, USB device, standard B
LAN port 1000/100/10 BASE-T
GPIB port IEEE 488.2 standard interface, 24 pin
Segment control port 2 x D-sub, 9 pin
Mechanical, Environmental and Maintenance Specifications