Atec Agilent-81180A - Manual (Page 16)

16
Marker outputs
Characteristics Description
Connector type SMB
Number of markers Two markers per channel
Type of output Differential (+) and (-) outputs
Impedance 50 Ω, typical
Level control Specified into 50 Ω, levels double into high impedance
Voltage window 0 V to 1.25 V, single-ended; 0 V to 2.5 V, differential
Low level 0 V to 0.8 V, single-ended; 0 V to 1.6 V, differential
High level 0.5 V to 1.25 V, single-ended; 1 V to 2.5 V, differential
Resolution 10 mV
Accuracy 10% of setting
Width control 0 SCLK periods to segment length
Position control 0 to segment length in 4 point increments
Marker resolution 4 SCLK periods (programmed as part of the output waveform)
Initial delay 1) 3.5 ns, +1 sample clock period, typical
Initial skew between marker
1 and marker 2
< 100 ps, typical
Variable delay control Separate for each marker
Range 0 to 3 ns
Resolution 10 ps
Accuracy ± (10% of setting +20 ps)
Rise/fall time 1.0 ns, typical
SYNC output
Characteristics Description
Connector type SMA
Type of output Single ended
Source Channel 1 or channel 2
Waveform Pulse (32 points width), WCOM (waveform duration pulse)
Impedance 50 Ω, typical
Amplitude 1.2 V, typical; doubles into high impedance
Variable position control
Range
0 to segment length
Resolution 32 points
Rise/fall time 2 ns, typical
Variable width control
Range
32 points to segment length
Resolution 32 points
¹ ) Analog output to marker output