Atec Agilent-5000 Series - Manual (Page 17)

Performance characteristics
(continued)
Channel triggering
Range (internal) ±6 div from center screen
Sensitivity 1 < 10 mV/div: greater of 1 div or 5mV; ≥ 10 mV/div: 0.6 div
Coupling AC (~10 Hz), DC, noise reject, HF reject and LF reject (~50 kHz)
1 Denotes warranted specifications, all others are typical. Specifications are valid after a 30-minute warm-up period and ±10° C from firmware calibration temperature.
External (EXT) triggering DSO50x2A DSO50x4A
Input impedance 1 MΩ ±3% || 12 pF or 50 Ω ±1% 1.015 kΩ ±5%
Maximum input CAT I 300 Vrms, 400 Vpk; transient overvoltage 1.6 kVpk ±15 V
CAT II 100 Vrms, 400 Vpk
with N2863A 10:1 probe: CAT I 600 V, CAT II 300 V (DC + peak AC)
with 10073C 10:1 probe: CAT I 500 Vpk, CAT II 400 Vpk
5 Vrms with 50-Ω input, CAT I
Range DC coupling: trigger level ± 1 V and ± 8 V ±5 V
Sensitivity For ± 1V range setting: DC to 100 MHz, 500 mV
DC to 100 MHz, 100 mV, >100 MHz to bandwidth of
the oscilloscope, 200 mV
For ±8 V range setting:
DC to 100 MHz, 250 mV; >100 MHz to bandwidth of
the oscilloscope, 500 mV
Coupling AC (~10 Hz), DC, noise reject, HF reject and LF reject (~50 kHz)
Probe ID Auto probe sense and AutoProbe interface
Agilent- and Tektronix-compatible passive probe sense
Display system
Display 6.3‑inch (161 mm) diagonal color TFT LCD
Display update rate Up to 100,000 waveforms/sec in real-time mode
Resolution XGA:
768 vertical by 1024 horizontal points (screen area);
640 vertical by 1000 horizontal points (waveform area)
256 levels of intensity scale
Controls Waveform intensity on front panel. Vectors on/off; infinite persistence on/off,
8 x 10 grid with intensity control
Built-in help system Key-specific help displayed by pressing and holding key or softkey of interest
Real-time clock Time and date (user adjustable)
17