Atec EMCP-MIG2000-6 - Manual (Page 8)

TECHNICAL SPECIFICATION E-MIG2000-6
4 Technical data
4.1 Voltage Spike waveform MIL-STD-461F CS106
Waveform in the calibration set up: 5 ohm load
Rise time 1.5us ± 0.5us
Fall time 3.5us ± 0.5us
Duration 5us ± 22%
Underswing < 120V
Voltage Settings 100V to 500V
Repetition rate max. 10 Hz
Polarity pos. / neg.
Source Impedance >2 Ohm
Test time 1 up to 29999 s
4.2 Rectangular waveform MIL-STD-461F CS115
Waveform in the calibration set up: VERI-MIL2
Rise time < 2ns ± 10%
Fall time < 2 ns
Duration > 30 ns
current range into 100 Ohm 1.00 A up to 10.0 A With coupler
Settings Ipeak 1.00 A up to 15.0A See display
Repetition rate max. 30 Hz (0.033s) +10% -0%
Polarity pos. / neg.
Source Impedance 50 Ohm
Test time 1 up to 29999 s
4.3 Damped oscillatory MIL-STD-461F, CS116
Waveform in the calibration set up: VERI-MIL2
Oscillation frequency 10, 100 kHz, 1, 10, 30 100
MHz
Q - Damping 15 ± 5
Current range into 100 Ohm - Plug-in CS116-10k..10M with injection probe CN-MIG-BT
Plug-in CS116-10k..10M „one output“ 0.02 A up to 0.20 A 10 kHz Z
≈ 10 Ohm
0.20 A up to 2.00 A 100 kHz Z
≈ 10 Ohm
1.00 A up to 15.0 A 1 MHz Z
≈ 50 Ohm
2.00 A up to 12.0 A 10 MHz Z
≈ 50 Ohm
Current range into 100 Ohm - Plug-in CS116-30M..100M with injection probe CN-MIG-BT2
Plug-in CS116-30M+100M „two
outputs“ 2.00 A up to 12.0 A 30 MHz Z
≈ 50 Ohm
1.0 A up to 6.00 A 100 MHz Z
≈ 50 Ohm
Repetition rate 0.5 up to 999 s
Polarity positive and negative programmable
Test time 1 up to 29999 seconds
CS116-10k..10M parameter programmable: frequency, Ip,
polarity, test time, repetition, etc.
0 7 . 0 5 . 2 0 0 9 E M C P A R T N E R A G 8 / 1 4